AS5013-IQFT-1000【PDF 15/32 页】IC ENCODER HALL SENSOR 16-QFN

www.ams.com/AS5013

Revision 1.11

15 - 32

AS5013

Datasheet - Detailed Description

High Speed Mode.

The AS5013 is capable to work in HS-mode.

For switching to HS-mode the Master has to send the sequence: START, MASTER CODE, NACK. This sequence is sent in FS-mode. As no

device is allowed to acknowledge the master code, the master code is followed by a not-acknowledge. After a device receives the master code it

has to switch from FS-settings to HS-settings within t

SU.STA

which is 160ns for HS-mode. The device stays in HS-mode as long as it does not

receive a STOP command. After receiving a STOP command it has to switch back form HS-settings to FS-settings, which has to be competed

within the minimum bus free time t

BUF

which is 500ns.

When switching to HS-mode the slave has to:

n Adapt the SDAH and SCLH input filters according to the spike suppression requirement required in HS-mode. In HS-mode spikes up to

10ns, in FS-mode spikes up to 50ns have to be suppressed.

n Adapt the setup and hold times according to the HS-mode requirement. In HS-mode an internal hold time for SDA for START/STOP

detection of 80ns (max. 150ns), in FS-mode an internal hold time of 160ns (max. 250ns) has to be provided.

n Adapt the slope control for SDAH output stage.

Figure 14. Data Transfer Format in HS-mode

Figure 15. A Complete HS-mode Transfer

Master code

Slave Address

R/W

DATA

Slave Address

F/S mode

Hs mode (current source for SCLH enabled)

F/S mode

Hs mode continues

< n bytes + ack >

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购